Frisco Garage Door Co
A Frisco garage door company built around the doors actually on this side of town
Frisco Garage Door Co repairs and replaces garage doors built for the area's 1985-2015 housing stock, serving Frisco and nearby towns from Paloma Creek to Bartonville.
Local detail
The Short Version
We work on garage doors and openers in Frisco and the towns around it. Most of the houses out here went up between 1985 and 2015, with the bulk of that stock dating to somewhere near 2002, and across the 26 named areas we cover, the 2000s builder-grade door and opener combo is what we see on nearly every call. That means a lot of steel sectional doors on standard torsion springs, a lot of chain-drive and belt-drive openers from the same handful of manufacturers, and hardware that's old enough now to be tired but young enough that parts aren't a problem. We don't do landscaping, fencing, or general handyman work.
Doors, springs, openers, tracks, panels, cables, rollers - that's the list. If a job needs a structural carpenter or an electrician for a sub-panel upgrade, we'll tell you that up front instead of taking the call anyway. Frisco sits in a moderate-heat climate band, which is easier on door hardware than a lot of the country deals with, but heat still dries out lubricant and stiffens seals over a couple of decades, and that shows up as noise and drag long before anything actually fails.
The area
Getting Hold of Us
Call 14697963113. That's the number, and it's the same one whether you're calling about a spring that let go this morning or an opener that's been grinding for a month and you're finally dealing with it. Our address is 5977 Preston Rd, Frisco, TX 75034.
We're not a call center routing you to a subcontractor three counties over - the person who answers knows the service area, which for us runs out to places like Paloma Creek about 8 miles off, Oak Point and Cross Roads in the 10-11 mile range, and further out to Aubrey, Corinth, and Lucas around 14 miles. Chapel Creek is close, about 2 miles south. If you're outside that radius, ask - we'd rather tell you plainly than have you wait on a truck that's an hour out.
What we find
Who Does the Work
The people who show up to your driveway are the ones who diagnose the problem and fix it - there's no separate estimator visit and separate repair visit unless the job genuinely needs a part we don't carry on the truck. Given how much of the housing here is 2000s-era builder stock, that's not often; the springs, cables, and drums that fail on those doors are common sizes.
We're straightforward about scope: if your opener is original to a 2002-built house and one repair after another is turning into a rebuild, we'll say so instead of running the meter. A household in this area making the median income of $116,974 can usually afford to replace a door outright rather than nurse a 20-year-old torsion system along, and sometimes that's the honest recommendation even though it's the bigger job.
How we work
What We Actually Do
Broken springs - torsion and extension - are the single most common call, and on doors from the 1985-2015 building wave that's almost always a straightforward swap. Opener repair and replacement, including the chain and belt-drive units common across the area's 2000s stock. Cable and drum replacement, track alignment, roller replacement, and panel repair or replacement on steel sectional doors. Off-track doors, doors that reverse on the way down, doors that won't respond to the remote at all.
What we don't do: new construction openings, gate operators, or general carpentry around a garage door frame. With roughly 52,521 owner-occupied houses in the wider service area, most of what we see repeats itself - the same spring sizes, the same opener boards, the same worn nylon rollers. That repetition is what lets us carry the right parts on the truck instead of guessing.
Questions
Common questions
Do you work outside Frisco itself?
Yes. We cover a wide radius around Frisco, including Paloma Creek, Oak Point, Cross Roads, Lake Dallas, Fairview, and towns as far as Aubrey, Corinth, Lucas, and Bartonville at the outer edge. If you're not sure whether you fall inside that area, call 14697963113 and ask before you book.
My house was built in the early 2000s - is that a common age for you?
It's the most common age we see. A large share of the housing in this area went up between 1985 and 2015, with a lot of it clustered around 2002, so the springs, cables, and opener models from that build era are what we stock parts for most often.
Do you replace doors or only repair them?
Both. Sometimes a repair is the right call, and sometimes a door from the original 2000s build has reached the point where another patch isn't worth it. We'll tell you which situation you're in rather than defaulting to the bigger job.
What don't you handle?
We don't do new construction rough openings, gate operators, or general carpentry work around the frame. If a job needs that kind of work first, we'll say so before we start.
Ready when you are
Need a garage door sorted in Frisco?
Frisco Garage Door Co repairs and installs garage doors, springs and openers in Frisco, TX and the surrounding area.