Service areas
The Towns We Drive To From Our Frisco Shop
Frisco Garage Door Co travels from Frisco, TX to nearby towns like Chapel Creek, Paloma Creek, and Bartonville - see distances and local housing notes here.
Local detail
The Jobs That Come Up Most
Almost everything we service in this radius was built in one long stretch - 1985 to 2015, with most of it going up around 2002. That matters more than people think. A torsion spring is rated for a set number of cycles, not years, and a door installed when a subdivision was new is now old enough that the original spring is at or past that count on a lot of houses at once. We see the same failure show up across a whole street in the same season.
Openers from that era are a mixed bag - some houses still run the chain-drive unit that came with the house, and the circuit boards in those don't love long stretches of heat. This area sits in a moderate heat band, not the worst in the state, but garages with south or west exposure still cook electronics and dry out nylon rollers faster than the shaded side of the same street. That shows up as a door that grinds going up in July and runs quiet again by October.
We don't see much of the older-home stuff - sagging wood jambs, knob-and-tube wiring near the opener circuit, that kind of thing. This housing stock is too young for it. What we do see: worn rollers, original springs at end of life, and openers that need a logic board more than a whole new unit.
The area
The Area and Its Housing
We're based in Frisco and drive out to the towns below. Closest first: Chapel Creek is about 2 miles south, then Paloma Creek at 8, Oak Point at 10, Cross Roads at 11, Lake Dallas, Fairview, and Shady Shores all around 12, Hickory Creek and Parker at 13, then Aubrey, Corinth, and Lucas at 14, Highland Village and Weston at 15, Murphy, New Hope, Farmers Branch, Lowry Crossing, and Copper Canyon at 16, St. Paul at 17, Lantana, Double Oak, Princeton, Melissa, Gunter, and Pilot Point at 18, and Bartonville furthest out at 20.
Across all of it, the housing tells the same story: mostly 2000s-era construction spread across 26 named areas in this radius, which is unusual for a metro this size - most cities have a mix of 1960s ranch stock, 1980s stock, and new builds all in one service area. Here it's tighter. That's 77,529 households total, 52,521 of them owner-occupied, with a median household income of $116,974. Practically, that means fewer rental-grade builder-basic doors and more owners who replace a door before it fails outright, rather than run it into the ground.
What we find
What You Pay For
You're paying for a truck that comes from Frisco, so travel time is part of the job on the towns farther out on this list. We don't pretend a call to Chapel Creek and a call to Bartonville cost us the same in drive time, and we schedule accordingly - the farther stops, past 15 miles or so, usually land on the next available slot rather than a same-day squeeze-in, especially late in the day.
Parts are the other piece. A spring or roller off the shelf goes on the truck same trip. A specific opener logic board or a panel match for a less common door color can mean a short wait on the part itself, not on us getting there. We'd rather tell you that up front than promise same-day on something we don't have in hand.
What you're not paying for is a guess. Because the housing stock in this radius is close in age, we generally know what we're walking into before we open the garage - original spring, original opener, rollers due - which cuts down on the diagnostic time that pads a lot of service calls elsewhere.
27 areas coveredTowns we serve
Service Areas Around Frisco
Questions
Common questions
Do you have a shop or office in my town?
No - Frisco Garage Door Co is based in Frisco and drives out to the towns on this list, from Chapel Creek at 2 miles to Bartonville at 20. We don't keep a satellite location in any of them; the truck comes from here.
Why does my garage door opener act up in the summer?
This area sits in a moderate heat band, and a garage with west or south sun exposure runs hotter than the rest of the house. That heat is hard on opener circuit boards and dries out nylon rollers faster, which is why a door that ran fine all spring can start grinding or sticking once the heat sets in.
My house was built in the early 2000s - is the door original?
Most homes across this service radius went up between 1985 and 2015, with a lot clustered around 2002, so if your neighborhood matches that window, there's a real chance the spring and opener are original to the build and past a normal service life.
Can you come same-day if I'm out past 15 miles?
Sometimes, but the towns farther out on our list - past 15 miles or so - more often land on the next available slot instead of a same-day fit, particularly later in the day. We'd rather give you an accurate window than rush a promise.
Ready when you are
Need a garage door sorted in Frisco?
Frisco Garage Door Co repairs and installs garage doors, springs and openers in Frisco, TX and the surrounding area.